| Top rated - hschwartz3's Gallery |
cut off cotter pin installed in drill211 viewshschwartz3
(2 votes)
|
|
cut-off cotter pin with end ground smoth on bench grinder.163 viewshschwartz3
(1 votes)
|
|
cotter pin installed in drill to lap valves212 viewshere I used a cut-off cotter pin (cause its harder than plain old wire) installed in the chuck of my variable speed drill to lap the valves. worked suprisingly well. I did all the valves this way.hschwartz3
(1 votes)
|
|
valve lapping tools, no good211 viewsAfter the suction cup tool (top) didn't work, I tried super gluing a cut off pencil to the valve but it kept popping off. Mildly successful,I believe this would work with a larger dow rod. ( tip - make sure end glued to valve is cut square or it'l wobbles as you widdle. Next I tried my cir-clip pliers keyed in the small dimples on top of the valve. This was hard to put pressure and turn but soewhat succesful. It led to my biggest break through.hschwartz3
(1 votes)
|
|
|
|
