Notice: Undefined offset: 8192 in /home/cubfest/public_html/photos/include/debugger.inc.php on line 112

Notice: Undefined offset: 8192 in /home/cubfest/public_html/photos/include/debugger.inc.php on line 112
FarmallCub | Cubfest Photo Gallery - Top rated

 FarmallCub | Cubfest Photo Gallery

Photo host for users of the FarmallCub.com forum
Home > User galleries

Top rated - User galleries
girl_friend.jpg
Girl Friend49 viewsgil
(1 votes)
Helper_Spring_Parts.JPG
Rick's Handiwork82 viewsdon mccombs
(1 votes)
240_1.jpg
30 viewssilverta16
(1 votes)
Combination_Jointer.jpg
Combination Jointer61 viewsdon mccombs
(1 votes)
P7150385.JPG
44 viewsponcho
(1 votes)
P7150386.JPG
44 viewsponcho
(1 votes)
P7150387.JPG
43 viewsponcho
(1 votes)
Front_Axle_Wedges.jpg
Front Axle Wedges97 viewsdon mccombs
(1 votes)
DSC00002~52.jpg
Left side support135 viewsbillyandmillie
(1 votes)
DSC00003~33.jpg
Right side support129 viewsbillyandmillie
(1 votes)
DSC00002~51.jpg
Final attempt with corner rounded117 viewsbillyandmillie
(1 votes)
DSC00001~72.jpg
I think this will be the final attempt126 viewsbillyandmillie
(1 votes)
DSC00001~71.jpg
side shot of the new attempt126 viewsbillyandmillie
(1 votes)
DSC00002~50.jpg
another twist to the support rod123 viewsbillyandmillie
(1 votes)
Brace1.jpg
231 viewsHarold Roberts
(1 votes)
Brace2.jpg
259 viewsHarold Roberts
(1 votes)
DSC00001~70.jpg
Picture showing the "Lombard" turnbuckle design124 viewsbillyandmillie
(1 votes)
DSC00002~49.jpg
Picture showing the complete setup, comes with both front and back grade 8 bolts112 viewsYou'll notice the loop on the front end. This was needed because the 2 holes on the front and back of the engine were not lined up. I needed to somehow fasten each end, and yet have the turnbuckle design for an adjustable fit.billyandmillie
(1 votes)
DSC00001~69.jpg
Another picture of the adjustable support rod120 viewsThe section with the arrow is fully adjustable to achieve the desired tension.billyandmillie
(1 votes)
DSC00002~48.jpg
An adjustable 7/8" rod, split in the middle, turnbuckle style used to put tension on the front ear132 viewsThe rod with the long arrow is adjustable. Flats are milled onto the rod below the starter to grip during adjustments. Just place a feeler guage between the back engine ear and the rod, adjust till the fit is reached, remove the feeler, then torque the back bolt which places that much tension on the front earbillyandmillie
(1 votes)
3182 files on 160 page(s) 111