| Top rated - Southwest Arkansas CubFest 2011 |
124 viewsIf you look real close- you can figure out what that is. It is an ash hole!randallc
(1 votes)
|
|
33 viewsmeasuring the cylinder walls.randallc
(1 votes)
|
|
32 viewsA few opinions on the notch between 3rd and 4th.randallc
(1 votes)
|
|
32 viewsA check of the bearing, found the standard bearings had been replaced with a .10.randallc
(1 votes)
|
|
29 viewsAn issue. That little notch between 3rd and 4th at the water jacket and head bolt hole. Problem or not?randallc
(1 votes)
|
|
28 viewsA look underneath the oil pan.randallc
(1 votes)
|
|
|
29 viewsLunch Saturday. Couldn't hardly work for eating. Good stuff...randallc
(1 votes)
|
|
|
|
|
30 viewstmays behind the helmet watches.
randallc
(1 votes)
|
|
|
32 viewsLocal cub owner, LT's cub and little green machine. Interesting!randallc
(1 votes)
|
|
29 viewsRustycub and his dad was at the presentation by Garycharles on sizeing up the headless-C-60.randallc
(1 votes)
|
|
131 viewsDaniel Barbee and Mike from Louisiana as Garycharles points out some issues with the Headless C-60.randallc
(1 votes)
|
|
31 viewsThe Chief starts his welder presentation.randallc
(1 votes)
|
|
39 viewsThe feast is cooking in Mike's Dutch Oven.randallc
(1 votes)
|
|
52 viewsLining up for the feast on set up day.randallc
(1 votes)
|
|
51 viewsMany thanks to Andrea Billinglesy and her mom for the much needed help in getting the stuff lined out.randallc
(1 votes)
|
|
42 viewsAfter supper, no work going on now.randallc
(1 votes)
|
|
| 35 files on 2 page(s) |
 |
1 | |
|
