| Most viewed - DaveSaver's Gallery |
|
|
Grill Frame26 viewsOrginal grill welded to frame made by previous owner then bolted to front of tractor cowl #1DaveSaver
|
|
Grill Welds26 viewsNeed to remove grill from frame modification made by previous owner #1DaveSaver
|
|
Grill Hole25 viewsNeed to fill and repair hole made by previous owner #1DaveSaver
|
|
Right Overview24 viewsCame with IH 1A Tiller with left and right extensions Purchased April 2007 #2
It's a runner and although leaky the hydraulics work.DaveSaver
|
|
The Arrival23 views52_Cub_03 Arrives home 6:15 AM May 2006DaveSaver
|
|
Load of Brush23 viewsOne of four loads of brush from trimming the lane.DaveSaver
|
|
Boat winch rigged to raise and lower Hyd press bed23 viewsThis was a temporary rigging some 15 years ago to test the theory if this would work. It's still working. I bolted the winch to the press using the existing holes in the winch. I had purchased a 450 foot roll of vinyl covered aircraft cable from a yard sale so I used it for the cable. A couple of pulleys from the hardware store and some aircraft cable clamps is all it took. Works great.DaveSaver
|
|
|
|
Anna Age 720 viewsAnna wants to drive daddy's tractorDaveSaver
|
|
|
Aircraft cable from winch to other side20 viewsWelded a rod across the top of the press and then clamped a pulley to the rod. Did this on both sides.DaveSaver
|
|
Brenda age 317 viewsLoves to sit on daddy's tractorDaveSaver
|
|
Winch with cable going up to first pulley16 viewsI ran off a length of cable doubled it and attached it to the winch. One half dropped to the winch side of the bed and the other half over the top through two pulleys one on each side of the top of the press.DaveSaver
|
|
Vinyl coated aircraft cable attached to press bed15 viewsI just drilled two holes and threaded the cable through and attached back to it's self with a cable clampDaveSaver
|
|
|
| 35 files on 2 page(s) |
 |
|
2 |
|
