Search results - "press" |
Original Cub Cadet1102 viewsI bought this for $20 on 9-19. It was parked in an alley waiting for removal. When I expressed an interest in it, the Cub increased in value, but not much!
|
|
TC valve questions112 viewsHow to remove the 'safety valve' 'pressure regulator valve' and the 'check valve'?Buzzard Wing
|
|
cleaning78 viewsAfter first day of pressure washingbrian c
|
|
Vinyl coated aircraft cable attached to press bed15 viewsI just drilled two holes and threaded the cable through and attached back to it's self with a cable clampDaveSaver
|
|
Aircraft cable from winch to other side20 viewsWelded a rod across the top of the press and then clamped a pulley to the rod. Did this on both sides.DaveSaver
|
|
Winch with cable going up to first pulley16 viewsI ran off a length of cable doubled it and attached it to the winch. One half dropped to the winch side of the bed and the other half over the top through two pulleys one on each side of the top of the press.DaveSaver
|
|
Boat winch rigged to raise and lower Hyd press bed23 viewsThis was a temporary rigging some 15 years ago to test the theory if this would work. It's still working. I bolted the winch to the press using the existing holes in the winch. I had purchased a 450 foot roll of vinyl covered aircraft cable from a yard sale so I used it for the cable. A couple of pulleys from the hardware store and some aircraft cable clamps is all it took. Works great.DaveSaver
|
|
rear elevated with fast hitch down pressure139 viewsgotowin
|
|
|
|
hyd schematic308 viewshyd. circuit schematic containing power beyond, pressure control valve, return line filter, and stackable valve options.gotowin
|
|
|
Carl and Billy Ray unloading some of the Cub-Express special mdse.162 viewsCarl's New Trailer can probably haul two Cubs.Arizona Mike
|
|
Pressure gauge attached to the hydraulic manifold101 viewslurker carl
|
|
|
|
|
|
|
sandpaper_press_open11 viewssandpaper_press_opendrspiff
|
|
|