| Last additions - User galleries |

9 viewsWelded the corners and ground them down. Added some "L" brackets with tie-downs.StantonSep 26, 2014
|
|

9 viewsReady for some primer and paint.StantonSep 26, 2014
|
|

9 viewsRusted old ammeter switch box. Had a large wasp nest in there.StantonSep 26, 2014
|
|

9 viewsJust rusty and in need of a good cleaning.StantonSep 26, 2014
|
|

9 viewsCleaned up and welded a piece to minimize the wire opening in the bottom. This should keep my little winged "friends" from building any more nests in there.StantonSep 26, 2014
|
|

9 viewsOld cap as found when purchased.StantonSep 24, 2014
|
|

9 viewsOld "cap" made up of series of washers.StantonSep 24, 2014
|
|

9 viewsGetting ideas roughed out.StantonSep 24, 2014
|
|

10 viewsPaper plans becoming steel reality.StantonSep 24, 2014
|
|

9 viewsOld vs. NewStantonSep 24, 2014
|
|

9 viewsTest fit.StantonSep 24, 2014
|
|

9 viewsOil cap painted and installed.StantonSep 24, 2014
|
|

10 viewsBuy a 1-1/4" plumbing drain union from your local plumbing supply or big box store. This will be the dial housing. A piece of glass and steel plate was cut to fit inside the ring.StantonSep 24, 2014
|
|

9 viewsAnother windshield wiper blade support for the dial shaft.StantonSep 24, 2014
|
|

12 viewsBent windshield wiper blade support for the frame.StantonSep 24, 2014
|
|

9 viewsShaping point on gauge dial arm.StantonSep 24, 2014
|
|

10 viewsClean / remove paint from gas cap prior to welding.StantonSep 24, 2014
|
|

11 viewsWelded gauge dial housing to gas cap.StantonSep 24, 2014
|
|

11 viewsRough draft.StantonSep 24, 2014
|
|

11 viewsReady for assembly.StantonSep 24, 2014
|
|
| 14447 files on 723 page(s) |
 |
 |
 |
 |
 |
 |
 |
31 |  |
 |
 |
 |
 |
|