| Last additions |
valve lapping tools, no good211 viewsAfter the suction cup tool (top) didn't work, I tried super gluing a cut off pencil to the valve but it kept popping off. Mildly successful,I believe this would work with a larger dow rod. ( tip - make sure end glued to valve is cut square or it'l wobbles as you widdle. Next I tried my cir-clip pliers keyed in the small dimples on top of the valve. This was hard to put pressure and turn but soewhat succesful. It led to my biggest break through.hschwartz3Aug 17, 2008
|
|
cylinder deck before cleaning168 viewshschwartz3Aug 17, 2008
|
|
Engine deck before cleaning185 viewshschwartz3Aug 17, 2008
|
|
cylinder deck after cleaning201 viewsalot of pitting on cylinder #2hschwartz3Aug 17, 2008
|
|
Exhaust vavle xcylinder #2 and flashlight.237 viewsAgain, tried to get a picture of the light showing around cyl. #2 exhaust valve but it didn't quite show up.hschwartz3Aug 17, 2008
|
|
Close-up of #2 cylinder valves252 viewsI have a LED flashlight held up to the exhaust manifold port and can see lght all around the exhaust valve in the closed position. I turned the light off in the garage to get a picture of this, but the camera flash foiled that idea.hschwartz3Aug 17, 2008
|
|
|
|
|
|
|
Cubs at local show197 viewsRAW in IAAug 16, 2008
|
|
Cub damaged in tornado210 viewsRAW in IAAug 16, 2008
|
|
Farmall B damaged in tornado216 viewsRAW in IAAug 16, 2008
|
|
|
|
|
|
|
|
|
|
| 27665 files on 1384 page(s) |
 |
|
|
|
|
|
|
999 | |
|
|
|
|
|
