| Last additions |
|
|
|
|
10 viewsThe old battery box had a couple nasty cutouts where the battery cables went in and out. Cut out the old openings and squared them up, ready for piecing and welding some new ones in.StantonSep 26, 2014
|
|
9 viewsPieced some new sheet metal into the old openings.StantonSep 26, 2014
|
|
9 viewsWelded and ground down the old openings.StantonSep 26, 2014
|
|
9 viewsTop is marked out on sheet metal with a Sharpie pen.StantonSep 26, 2014
|
|
9 viewsEasier to cut the battery cable holes while it's still flat.StantonSep 26, 2014
|
|
13 viewsBattery cable holes cut. Ready for bending.StantonSep 26, 2014
|
|
14 viewsHooked up the sheet metal bender and with a little effort got this.StantonSep 26, 2014
|
|
10 viewsReady for welding.StantonSep 26, 2014
|
|
9 viewsWelded the corners and ground them down. Added some "L" brackets with tie-downs.StantonSep 26, 2014
|
|
9 viewsReady for some primer and paint.StantonSep 26, 2014
|
|
9 viewsRusted old ammeter switch box. Had a large wasp nest in there.StantonSep 26, 2014
|
|
9 viewsJust rusty and in need of a good cleaning.StantonSep 26, 2014
|
|
9 viewsCleaned up and welded a piece to minimize the wire opening in the bottom. This should keep my little winged "friends" from building any more nests in there.StantonSep 26, 2014
|
|
9 viewsOld cap as found when purchased.StantonSep 24, 2014
|
|
9 viewsOld "cap" made up of series of washers.StantonSep 24, 2014
|
|
9 viewsGetting ideas roughed out.StantonSep 24, 2014
|
|
10 viewsPaper plans becoming steel reality.StantonSep 24, 2014
|
|
| 27665 files on 1384 page(s) |
 |
|
|
|
|
|
|
69 | |
|
|
|
|
|
