ISO Engine Mount Replacement project |
|
TITLE |
+ |
- |
FILE NAME |
+ |
- |
DATE |
+ |
- |
POSITION |
+ |
- |
|
|
The engine raised out of my 145019 viewsIt was a bear to get this engine out. I had to take the axle out in order to get the bottom bolts out. (2 bolts were under axle) geoaidan
|
|
Steel ISO mounts made by Brian Miller39 viewsSteel ISO mounts milled by Brian Miller. Works great! geoaidan
|
|
Steel ISO mount kit16 viewsSteel mount was milled by Brian Miller. The other pieces are items I purchased at Lowe's. Grade 8. geoaidan
|
|
Good Rail, bad mounts16 viewsThis is the right hand side rail for my 1450. Mounts were gone- they were probably just 1-2 years old. geoaidan
|
|
Engine lifted out, full view42 viewsFull view of how I got the engine out. Used two winch straps to lift engine 5" out of tractor. Replaced mounts, then jacked the tractor up to the engine and bolted engine in place, then took winch straps off. geoaidan
|
|
Beam17 viewsBefore I did the project, I had to reinforce my ceiling beam to support the 120 lb Kohler engine. geoaidan
|
|
Bad Rails, mounts gone13 viewsThis is the bad rail that came off my 1450, left hand side. Notice the gouge. It is as deep as a quarter! The mounts are totally gone. geoaidan
|
|
|
|