| Most viewed - User galleries |
|
|
Farmall Cub Encyclopedia215 viewsCub-Bud
|
|
|
|
|
|
tire clearance at base mount 2-16-06214 viewsgotowin
|
|
|
|
|
|
cotter pin installed in drill to lap valves212 viewshere I used a cut-off cotter pin (cause its harder than plain old wire) installed in the chuck of my variable speed drill to lap the valves. worked suprisingly well. I did all the valves this way.hschwartz3
|
|
|
|
|
|
valve lapping tools, no good211 viewsAfter the suction cup tool (top) didn't work, I tried super gluing a cut off pencil to the valve but it kept popping off. Mildly successful,I believe this would work with a larger dow rod. ( tip - make sure end glued to valve is cut square or it'l wobbles as you widdle. Next I tried my cir-clip pliers keyed in the small dimples on top of the valve. This was hard to put pressure and turn but soewhat succesful. It led to my biggest break through.hschwartz3
|
|
cut off cotter pin installed in drill211 viewshschwartz3
|
|
|
|
|
Forgotten Farmall "A"211 views250867boldpsi
|
|
planter side view211 viewsKGM
|
|
|
| 14439 files on 722 page(s) |
 |
|
|
|
|
|
|
18 | |
|
|
|
|
|
