Most viewed - '57 Farmall 130 |
129 viewsAxle had to be dropped out as the steering is too sloppy again.EZ
|
|
112 viewsEZ
|
|
107 viewsEZ
|
|
Popping Red74 viewsEZ
|
|
TC Pump72 viewsEZ
|
|
F130 is Done!68 viewsTinker for 10 years and this will come out the end. I like it.
Runs great and will push a huge amount of snow this winter.EZ
|
|
Done64 viewsAll parts back in. No parts left over.
You can see old O rings on the left. Leftover O rings from kit.
Phone, to call a friend.EZ
|
|
130 vs Cub Loboy59 viewsThe 130 will replace the Loboy for snow moving chores this winter.
The loboy deserves a good rest after at least 10 Northern Ontario winters.EZ
|
|
130 Tranny59 viewsThis shows a broken oil slinger and possible worn gears?EZ
|
|
SmallTire53 viewsHere's the the temp wheel on the right hub.EZ
|
|
47 viewsParts mapped and filed.EZ
|
|
TempHub 47 viewsI made up this temporary hub to install a set of small rears so as to move tractor around shop while working on it.EZ
|
|
Die Grind46 viewsUsed the die grinder to remove a small area so pump 383013R94 would fit.EZ
|
|
Sloppy Steering45 viewsWell I found the source of the sloppy steering.
Glad I opened up that box.EZ
|
|
TouchControl45 viewsThe Touch Control is cleaned, re-O-ringed, gasketed, booted, and primed.EZ
|
|
Poor cast on A&I aftermarket WaterPump43 viewsThe angle of the belt clearance cut on the inlet tube is wrong, no room for belt to spin without rubbing on inlet tube.
Tried to die grind some off, but cannot go deep enough without grinding a hole through the pipe.
Only cure now is to use a narrower than stock belt.EZ
|
|
Block clean.43 viewsHere's how she looked after her bath.EZ
|
|
41 viewsThese are my gear sets, including the broken oiler gear.EZ
|
|
130 in progress41 viewsThe finals and transmission have been back on for a while now. today I removed the Touch Control to rebuild it. EZ
|
|
Before grind40 viewsThis area had to be ground a bit to fit the pump in.EZ
|
|
|