| Search results - "cable" |
Vinyl coated aircraft cable attached to press bed15 viewsI just drilled two holes and threaded the cable through and attached back to it's self with a cable clampDaveSaver
|
|
Aircraft cable from winch to other side20 viewsWelded a rod across the top of the press and then clamped a pulley to the rod. Did this on both sides.DaveSaver
|
|
Winch with cable going up to first pulley16 viewsI ran off a length of cable doubled it and attached it to the winch. One half dropped to the winch side of the bed and the other half over the top through two pulleys one on each side of the top of the press.DaveSaver
|
|
Boat winch rigged to raise and lower Hyd press bed23 viewsThis was a temporary rigging some 15 years ago to test the theory if this would work. It's still working. I bolted the winch to the press using the existing holes in the winch. I had purchased a 450 foot roll of vinyl covered aircraft cable from a yard sale so I used it for the cable. A couple of pulleys from the hardware store and some aircraft cable clamps is all it took. Works great.DaveSaver
|
|
Phase One29 viewsnew battery and cables and she fired right up after sitting for 4 years.Stans Cub
|
|
Battery Cable Clips27 viewsPurchased PartsBob Grieb
|
|
122 viewsI used welding cable for starter lead and I put a black hose over it for where it goes under the platform for safetyrustynuts
|
|
|
|
|
|
|
Magneto13 viewsThis is a great feature. It will save me the cost of a new battery and cables.Ronny Bailey
|
|
16 viewsWith the 750# Goldwing on the boom, the front of the cub can be lifted off the ground with one hand. To lift anything heavier, the lift cable would have to be attached lower on the pole, or the pole would have to be more upright.tulalipjames
|
|
13 viewsBattery cable holes cut. Ready for bending.Stanton
|
|
9 viewsEasier to cut the battery cable holes while it's still flat.Stanton
|
|
10 viewsThe old battery box had a couple nasty cutouts where the battery cables went in and out. Cut out the old openings and squared them up, ready for piecing and welding some new ones in.Stanton
|
|
|
|
|
|
Crawler loader and cat D-7 cable lift dozer159 viewsThe Cat D-7 is on the right.SONNY
|
|
|
|
