Search results - "Base" |
Finally. The base tractor is done.153 viewsCecil
|
|
|
cyl. base mount 2-16-06189 viewsgotowin
|
|
tire clearance at base mount 2-16-06214 viewsgotowin
|
|
center blade base mount 2-16-06205 viewsgotowin
|
|
Brake rod goes into the rear of the bull housing on the long wheelbase LoBoy107 viewslurker carl
|
|
portable_stump_base10 viewsportable_stump_basedrspiff
|
|
3_hole_jack_base13 views3_hole_jack_basedrspiff
|
|
3_hole_jack_base_with_jack13 views3_hole_jack_base_with_jackdrspiff
|
|
1_hole_jack_base12 views1_hole_jack_basedrspiff
|
|
1_hole_jack_base_with_jack13 views1_hole_jack_base_with_jackdrspiff
|
|
Set Up for 172 planter194 viewsPOAX seed hopper basePete1941
|
|
Set Up for 172 planter265 views53-A Fertilize Hopper BasePete1941
|
|
|
|
|
Oooops!48 viewsYou can see the peak where the shingles were repaired a couple years ago. The winds get so bad, that it rips the shingles right off and they are all glued down with ashphalt based mastic. The last open section of ladder will be about 13 " wider than the primary ladders, which are standard 16" wide. This will be a bit easier to finish the roof, and a lot faster. With the use of support legs, it will be as strong as building a partial gable end wall.Rudi
|
|
Bullet Light Project - First Hole Drilled180 viewsTLAR Method... marked the outline of the bullet light base with a pencilWisconsinCubMan
|
|
Bullet Light Project - Marking the spot of the bullet light base170 viewsWisconsinCubMan
|
|
Jacked up for 20+ years93 viewsRaised it up a little higher and put a board under the tire. The jack base had rusted so bad it disintegrated.Ronny Bailey
|
|
30 files on 2 page(s) |
|
1 | |
|