| Last additions - DaveSaver |
Utility Trailer Front Spring Mount79 viewsDaveSaverMar 21, 2007
|
|
Utility Trailer Side120 viewsDaveSaverMar 21, 2007
|
|
Utility Trailer Rear Spring Mount76 viewsThis is a utility Trailer I own that appears to use the same body as an IH trailerDaveSaverMar 21, 2007
|
|
Left Side Emblems21 viewsDaveSaverAug 28, 2006
|
|
Rear View Armor Trenching Blade29 viewsDaveSaverAug 28, 2006
|
|
|
|
Anna Age 720 viewsAnna wants to drive daddy's tractorDaveSaverJul 06, 2006
|
|
Brenda age 317 viewsLoves to sit on daddy's tractorDaveSaverJul 06, 2006
|
|
Load of Brush23 viewsOne of four loads of brush from trimming the lane.DaveSaverJul 06, 2006
|
|
The Arrival23 views52_Cub_03 Arrives home 6:15 AM May 2006DaveSaverMay 23, 2006
|
|
Boat winch rigged to raise and lower Hyd press bed23 viewsThis was a temporary rigging some 15 years ago to test the theory if this would work. It's still working. I bolted the winch to the press using the existing holes in the winch. I had purchased a 450 foot roll of vinyl covered aircraft cable from a yard sale so I used it for the cable. A couple of pulleys from the hardware store and some aircraft cable clamps is all it took. Works great.DaveSaverNov 04, 2005
|
|
Winch with cable going up to first pulley16 viewsI ran off a length of cable doubled it and attached it to the winch. One half dropped to the winch side of the bed and the other half over the top through two pulleys one on each side of the top of the press.DaveSaverNov 04, 2005
|
|
Aircraft cable from winch to other side20 viewsWelded a rod across the top of the press and then clamped a pulley to the rod. Did this on both sides.DaveSaverNov 04, 2005
|
|
Vinyl coated aircraft cable attached to press bed15 viewsI just drilled two holes and threaded the cable through and attached back to it's self with a cable clampDaveSaverNov 04, 2005
|
|
|
| 35 files on 2 page(s) |
 |
|
2 |
|
