'57 Farmall 130 |
 |
| TITLE |
+ |
- |
| FILE NAME |
+ |
- |
| DATE |
+ |
- |
| POSITION |
+ |
- |
|
|
Water Pump Ceramic Seal10 viewsThe rubber part of this seal appears to be damaged out of the box.EZ
|
|
|
10 viewsEZ
|
|
Leaktest water pump9 viewsSet up the pump with a couple temp gaskets and a backplate. Connect a length of abs pipe fill with water. Wait.EZ
|
|
Leaktest water pump setup9 viewsSet up the pump with a couple temp gaskets and a backplate. Connect a length of abs pipe fill with water. Wait.EZ
|
|
Water Pump body10 viewsShaft, impeller and seal removedEZ
|
|
Water Pump body12 viewsImpeller end of body where seal is inserted.EZ
|
|
Water Pump body w/parts16 viewsParts as they came out of the water pump body.EZ
|
|
17 viewsGrader blade plate for torque tubeEZ
|
|
Whammy bar17 viewsNeed to fabricate my own whammy bar to lift front grader bladeEZ
|
|
WpGaskets25 viewsGaskets for waterpump.
Aftermarket on the left
CASEIH on the rightEZ
|
|
Waterpumps29 viewsTop is aftermarket by A&I, Manufactured in Turkey.
Bottom is original.EZ
|
|
Waterpumps28 viewsThe aftermarket is a good copy from A&I.EZ
|
|
Waterpump 26 viewsAftermarket info on box from CaseIHEZ
|
|
Poor cast on A&I aftermarket WaterPump43 viewsThe angle of the belt clearance cut on the inlet tube is wrong, no room for belt to spin without rubbing on inlet tube.
Tried to die grind some off, but cannot go deep enough without grinding a hole through the pipe.
Only cure now is to use a narrower than stock belt.EZ
|
|
107 viewsEZ
|
|
112 viewsEZ
|
|
35 viewsEZ
|
|
starter bendix28 viewsEZ
|
|
ring gear wear29 viewsEZ
|
|
|
|
