'57 Farmall 130 |
|
TITLE |
+ |
- |
FILE NAME |
+ |
- |
DATE |
+ |
- |
POSITION |
+ |
- |
|
|
Starter Drive27 viewsRemoved the armature and starter drive.
Looks good, see no problem. Nothing broken, key is good, spring and bolts are OK.EZ
|
|
starter bendix28 viewsEZ
|
|
spec sheet31 viewsEZ
|
|
Snow blade bracket17 viewsHoles drilled, just need to cut the corners and finish.EZ
|
|
SmallTire53 viewsHere's the the temp wheel on the right hub.EZ
|
|
Sloppy Steering45 viewsWell I found the source of the sloppy steering.
Glad I opened up that box.EZ
|
|
Shaft and Key40 viewsFinally off! Also had to work that key with a punch. It had to come out for the assembly to come out as the key would not clear the bottom seal.
The steering rod bearing is still stuck in there though.EZ
|
|
ring gear wear29 viewsEZ
|
|
ring gear31 viewsEZ
|
|
Ready for parts33 viewsBlock cleaned and ready for new o rings and gaskets.EZ
|
|
Popping Red74 viewsEZ
|
|
Poor cast on A&I aftermarket WaterPump43 viewsThe angle of the belt clearance cut on the inlet tube is wrong, no room for belt to spin without rubbing on inlet tube.
Tried to die grind some off, but cannot go deep enough without grinding a hole through the pipe.
Only cure now is to use a narrower than stock belt.EZ
|
|
Pilot Shaft Bushing26 viewsPulled the axle today to get a better look at the steering.
Found the pilot shaft bushing wore in an oval shape.
The shaft just flops around in there. Could attribute to some of the play in the steering. EZ
|
|
Original and Spare Carbs16 viewsRequire kit to build one one out of 2.
Use original top and spare bottom.EZ
|
|
Oil slinger gear 354643-R1139 viewsEZ
|
|
New plug wires11 viewsEZ
|
|
Leaktest water pump setup9 viewsSet up the pump with a couple temp gaskets and a backplate. Connect a length of abs pipe fill with water. Wait.EZ
|
|
Leaktest water pump9 viewsSet up the pump with a couple temp gaskets and a backplate. Connect a length of abs pipe fill with water. Wait.EZ
|
|
Inside bottom of TC37 viewsLooks pretty clean to me.EZ
|
|
In Deep30 viewsNever thought I would ever get in 'this deep' into another tractor project.
I just want to paint this thing and get it back together.
But, I also want to do it right. The steering is very sloppy, so off comes the front axle.
EZ
|
|
|