Last additions - hschwartz3's Gallery |
cut-off cotter pin with end ground smoth on bench grinder.163 viewshschwartz3Aug 17, 2008
|
|
cut off cotter pin installed in drill211 viewshschwartz3Aug 17, 2008
|
|
cotter pin installed in drill to lap valves212 viewshere I used a cut-off cotter pin (cause its harder than plain old wire) installed in the chuck of my variable speed drill to lap the valves. worked suprisingly well. I did all the valves this way.hschwartz3Aug 17, 2008
|
|
valve lapping tools, no good211 viewsAfter the suction cup tool (top) didn't work, I tried super gluing a cut off pencil to the valve but it kept popping off. Mildly successful,I believe this would work with a larger dow rod. ( tip - make sure end glued to valve is cut square or it'l wobbles as you widdle. Next I tried my cir-clip pliers keyed in the small dimples on top of the valve. This was hard to put pressure and turn but soewhat succesful. It led to my biggest break through.hschwartz3Aug 17, 2008
|
|
Last updated albums - hschwartz3's Gallery |
Head Gasket, Valve adjustment , Carb Rebuild, and cleaning224 viewsA decent amount of carbon builup here. I wonder how much was there before the three seafoam treatments.hschwartz3Aug 14, 2008
|
|
Front mounted snowplow frame21 viewshschwartz3Feb 15, 2008
|
|
|
|